top of page

MAKO CARVE V1 - WINGFOIL - SURF FOIL

00185
199,00 €
In stock
1
Product Details

IN STOCK : Only 1 left, 152 for Takuma V2

The MAKO CARVE is available in 4 sizes: 142, 152, 172 & 176.
This tail is designed for a SURF FOIL and WINGFOIL practice in a CARVING and PUMPING perspective.
This stab provides great maneuverability while guaranteeing stability and consistency in your turns.
Its linear power does not generate over-immersion and allows you to focus on your trajectory.

142 : 31 cm wingspan

152: 32.5 cm wingspan
172: 34 cm wingspan

176 : 36 cm wingspan

172 & 176 are close in surface. However, the 176 has a slightly more homogeneous distribution with more surface at the ends (proportionally), it will be preferred VS the 172 if you are primarily looking for low end speed abilities. If you prefer maneuverability, choose the 172.

Kparts stabilizers have a flat area on both sides allowing it to be mounted above the fuselage (AXIS, FONE, CABRINHA etc) and below (TAKUMA, AFS, ARMSTRONG etc). The rear hole is oblong to allow a fixing center distance of 30 to 35mm depending on the foil brand.

The shims set chosen allows you to adapt all KPARTS stabilizers to your foil by adjusting the angle according to your needs.

Each tail comes with a cover, a set of shims that matches your foil (choose from the drop-down menu), 2 screws of greater length.

Tail wings made from G10 (compressed fiberglass), machined in our workshop in Brest.
The covers are made by hand in felt, in France (Saint Malo).
The shims are 3D printed with PETG.
Save this product for later
bottom of page